LifecardSight How To Mount, Set, & Dismount

How to Mount and Dismount

Make sure the [ARROW] on top of the rail is pointing to the muzzle end of the barrel. Set the back end of the rail to the back edge of the barrel seen on either side. The adhesive takes up to 72 hours to fully adhire. Mount your micro dot with the front back from the muzzle of the barrel.

Dismount by pressing firmly on one side until the adhesive starts to peel from the barrel. then press firmly from the other side as shown in the video.

How to Set the Adjustable Rear Sight

Once the front sight has been mounted tothe front of the barrle, place the pre-adjustable rear sight on the top of the pistol behind the rear of the barrel as shown in the video. Use one of the butterfly strips to hold the rear sight in place. Take a few shots at your target and slide the rear sight left or right to adjust. Once you have it lined up for windage visualy take note where it is setting and remove the butterfly strip, peel the adhesive cover off and place the rear sight where you took note of its placement. Press firmly and allow the adhesive 72 hours to fully adhire.

How to  Mount the Half Scale

Peel the adhesive cover, then place the small guide pin in the holse at the top of the pistol grip and line up the back edge with the back edge of the pistoll grip. Press firmly and al;low 72 hours for the adheive to adhire fully.

To dismount the Hlaf Scale press upward on the larger curved corner at the bottom firmly but do not over force it. OInce the adhesive starts peeling away pull the Hlaf Scale off the grip being mindful not to damage the guide pin.